Service Kits & Recycling
Omnitrack Heavy Duty Ball transfers – in continuous production since 1954.
Rapidly restore performance within minutes by using Service Kits ‘S1’ & ‘S2’ offering 2 levels of components & full overhaul instructions.
Factory reconditioning service for spring loaded & custom units as these may require tooling for safe disassembly.




To order state original part number, any identification mark & Service Kit required eg S1-9241.
If in doubt, contact us & we’ll keep you rolling!
1
Circlip
2
Top Cap
3
Felt Seal
4
Main Ball
5
Recirculating Balls
6
Retainer
7
Table
Replacement Units
& Spare Parts
Omnifloat


Remove
Snap fitting


Replacement parts available as spares. Alternative materials can be retro-fitted for extended durability & service.


Rubber Ball
Better Grip (Black)
70 Shore ‘A’ -20⁰C to +80⁰C S35R = Ball ⌀ 35mm S50R = Ball ⌀ 50mm
Better Grip (Black)
70 Shore ‘A’ -20⁰C to +80⁰C S35R = Ball ⌀ 35mm S50R = Ball ⌀ 50mm


Polyurethane Ball
Wear resistant (Caramel)
92 Shore ‘A’ -20⁰C to +80⁰C S35P = Ball ⌀ 35mm S50P = Ball ⌀ 50mm
Wear resistant (Caramel)
92 Shore ‘A’ -20⁰C to +80⁰C S35P = Ball ⌀ 35mm S50P = Ball ⌀ 50mm


High Temperature Ball
Heat resistant (Red)
80 Shore ‘A’ -20⁰C to +150⁰C S35HT = Ball ⌀ 35mm S50HT = Ball ⌀ 50mm
Heat resistant (Red)
80 Shore ‘A’ -20⁰C to +150⁰C S35HT = Ball ⌀ 35mm S50HT = Ball ⌀ 50mm


Factory reconditioning service & spares since